Analiza odkształceń elementów cienkościennych podczas frezowania stopu aluminium EN AW-7075
[ 1 ] Instytut Technologii Mechanicznej, Wydział Inżynierii Mechanicznej, Politechnika Poznańska | [ P ] employee
[ 1 ] Instytut Technologii Mechanicznej, Wydział Inżynierii Mechanicznej, Politechnika Poznańska | [ P ] employee
EN Analysis of deformations in thin-walled components during milling of EN AW-7075 aluminium alloy
polish
- frezowanie
- elementy cienkościenne
- drgania
- odkształcenia
- milling
- thin-walled components
- vibrations
- deformations
PL Rozprawa dotyczy frezowania cienkościennych elementów ze stopu EN AW-7075 w warunkach obróbki dokładnej. Omówiono problemy opisane w literaturze i stosowane rozwiązania. Badania przeprowadzono w dwóch etapach: obróbce konwencjonalnej oraz frezowaniu HSM. Opisano stanowiska, narzędzia i materiały, w tym stop Ti6Al4V. W obróbce konwencjonalnej sklasyfikowano odkształcenia, oceniono wpływ strategii zgrubnej, rodzaju frezowania (współbieżne/przeciwbieżne) oraz współczynnika H/L. Dominowały odkształcenia sprężyste Δls, istotnie wpływające na błąd płaskości; uwzględniono także wpływ temperatury. W obróbce HSM pojawiły się drgania samowzbudne, lecz technologia pozwoliła ponad 10-krotnie ograniczyć odkształcenia i utrzymać błąd płaskości poniżej 0,05 mm, kosztem jakości powierzchni. Pracę zakończono wnioskami i wskazaniem dalszych badań.
EN The thesis concerns the milling of thin-walled elements made of EN AW-7075 alloy under precision machining conditions. The problems described in the literature and the solutions applied are discussed. The research was conducted in two stages: conventional machining and HSM milling. The workstations, tools and materials, including the Ti6Al4V alloy, are described. In conventional machining, deformations were classified, and the influence of the roughing strategy, the type of milling (concurrent/counter-concurrent) and the H/L ratio were evaluated. Elastic deformations Δls dominated, significantly affecting the flatness error; the influence of temperature was also taken into account. Self-excited vibrations occurred in HSM machining, but the technology allowed for a more than 10-fold reduction in deformation and maintained flatness error below 0.05 mm, at the expense of surface quality. The work was concluded with conclusions and recommendations for further research.
105
mechanical engineering
public
Witold Habrat
Rzeszów, Polska
11.08.2025
polish
public
Janusz Śliwka
Gliwice, Polska
31.07.2025
polish
public
Krzysztof Żak
Opole, Polska
12.08.2025
polish
public
dissertation before defense
Poznań, Polska
03.10.2025