Metrological relations between the spray atomization parameters of a cutting fluid and formation of a surface topography and cutting force
[ 1 ] Instytut Technologii Mechanicznej, Wydział Inżynierii Mechanicznej, Politechnika Poznańska | [ P ] employee
2023
scientific article
english
- Minimum quantity lubrication (MQL)
- Volumetric air flow rate
- Cutting fluid mass flow rate
- Droplet size
- Surface topography
- Cutting force
EN Aerosol formation parameters are very important, as they are responsible for the ability of spray-forming droplets to penetrate the area to which they are applied. Research into modifying these parameters can therefore provide a solution for increasing the effectiveness of cooling and lubrication of the cutting zone during machining. This is particularly important for hard-to-cut materials such as titanium alloys, the machining of which requires the selection of effective cooling/lubricating methods to reduce tool wear or improve the machined surface quality. Previous research indicates that any modification in the air or oil flow rates – which form aerosols during cutting in minimized quantity lubrication (MQL) technique – contribute to an increase or decrease in the penetration of droplets into the cutting zone. It can consequently has a significant impact on machining results. This paper presents results on the effect of volumetric air flow rate P and cutting fluid mass flow rate E during the MQL cutting method on the machined surface topography after turning of Ti6Al4V alloy and the values of the cutting force. On the basis of conducted computational fluid dynamics (CFD) simulation studies, it was shown that the droplet size is more influenced by the change in volumetric air flow rate than cutting fluid mass flow rate and also that as the value of P increases, the droplet diameters decrease and the spray angle increases, which promotes the penetration of the cutting zone. As a result of the analysis of selected 3D surface roughness parameters, as well as contour maps, isometric views and material ratio curves, it was shown that the most favorable machined surface topography is being formed during MQL turning method with a volumetric air flow rate above 20 l/min. Whereby, with conditions of P = 30 l/min and E = 1.182 g/min, the machined surface topography is characterized by a uniform distribution of irregularity peaks and valleys, compared to the MQL turning with other tested values of aerosol formation parameters.
01.07.2023
113255-1 - 113255-20
Article Number: 113255
CC BY-NC-ND (attribution - noncommercial - no derivatives)
czasopismo hybrydowe
final published version
in press
200
5,6 [List 2022]