Depending on the amount of data to process, file generation may take longer.

If it takes too long to generate, you can limit the data by, for example, reducing the range of years.

Chapter

Download BibTeX

Title

Analysis of Cutting Force and Power Under the Conditions of Minimized Cooling in the Process of Turning AISI-1045 Steel with the Use of the Parameter Space Investigation Method

Authors

[ 1 ] Instytut Technologii Mechanicznej, Wydział Inżynierii Mechanicznej, Politechnika Poznańska | [ P ] employee

Scientific discipline (Law 2.0)

[2.9] Mechanical engineering

Year of publication

2020

Chapter type

chapter in monograph / paper

Publication language

english

Keywords
EN
  • EP/AW additives
  • cutting force
  • cutting power
  • MQC
  • dry cutting
Abstract

EN The work presents methods of cooling during turning of AISI-1045 steel: dry machining, minimum quantity cooling (MQC) and minimum quantity cooling with EP/AW (MQC + EP/AW) additives. Due to the increased number of variables (change of the parameters of cutting and forming emulsion mist), the method of Parameter Space Investigation was employed. The measurement of the cutting force was performed by means of a Kistler dynamometer type 9129AA and power consumption was measured with the use of a network parameter measurement device, MPS7. It has been found in the investigation that the air flow intensity has a crucial impact on the formation of the active medium in the MQC method. The lowest values of the cutting force and power have been observed when using the MQC + EP/AW method. Addition of phosphorate ester to the emulsion mist has resulted in an improvement of lubricating properties of the active medium by direct influence of the chemically active compounds in the cutting zone and, consequently, significant reduction of the cutting force and power in the process of turning the AISI-1045 steel.

Date of online publication

19.07.2020

Pages (from - to)

151 - 162

DOI

10.1007/978-3-030-49910-5_14

URL

https://link.springer.com/chapter/10.1007/978-3-030-49910-5_14

Comments

DOI nie działa poprawnie.

Book

Industrial Measurements in Machining

Presented on

International Conference on Industrial Measurements in Machining, IMM 2019, 11-12.09.2020, Opole, Polska

Ministry points / chapter

20

This website uses cookies to remember the authenticated session of the user. For more information, read about Cookies and Privacy Policy.